NinjaTek Cheetah TPU Filament - Print Settings:
235°C - 245°C
- Platform Temperature: Room temperature – 4°C
- Glue and/ or blue painters tape is suggested if not using a heated bed. In most cases, will stick to to most surfaces without glue or tape. Sticks well to bare glass and PEI surface.
- Print Speed: Top and bottom layers: 30-45 mm/ sec
- Infill speeds: 60-80 mm/ sec
- Layer 2+ use cooling fan if available.
- When switching from another polymer (such as ABS or PLA) purge thoroughly before starting a print.
- See official site for more information & support: ninjatek.com
